Table of Contents
Advertisement
Administrator's Handbook
If you specify v2-MD5, you must also specify a rip-send-key. Keys are ASCII strings with a maximum of
31 characters, and must match the other Gateway(s) keys for proper operation of MD5 support.
Depending on your network needs, you can configure your Motorola Netopia® Gateway to support RIP-
1, RIP-2, or RIP-2MD5.
set ip ethernet A rip-receive { off | v1 | v2 | v1-compat | v2-MD5 }
Specifies whether the Motorola Netopia® Gateway should use Routing Information Protocol (RIP) broad-
casts to update its routing tables with information received from other Gateways on your network.
If you specify v2-MD5, you must also specify a rip-receive-key. Keys are ASCII strings with a maximum
of 31 characters, and must match the other Gateway(s) keys for proper operation of MD5 support.
Additional subnets
See
"DHCP Settings" on page 153
set ip ethernet A subnet [ 2 ... 8 ] option [ on | off ]
Enables or disables additional LAN subnets. Up to seven additional subnets may be configured.
set ip ethernet A subnet n address ip_address
Specifies an IP address for the subnet n , when subnet n option is on.
set ip ethernet A subnet n netmask netmask
Specifies the subnet mask for the subnet n , when subnet n option is on.
Default IP Gateway Settings
set ip gateway option { on | off }
Specifies whether the Motorola Netopia® Gateway should send packets to a default Gateway if it does
not know how to reach the destination host.
set ip gateway interface {
Specifies how the Motorola Netopia
select ip-address, you must enter the IP address of a host on a local or remote network. If you spec-
ify ppp, the Motorola Netopia
IP-over-PPP Settings.
PPP interface.
NOTE:
For a DSL platform you must identify the virtual PPP interface [vccn], a number from 1 to
8.
168
for subnet range configuration commands.
ip-address | ppp-vccn }
®
Gateway should route information to the default Gateway. If you
®
unit uses the default gateway being used by the remote PPP peer.
Use the following commands to configure settings for routing IP over a virtual
Advertisement
Table of Contents
