Config Commands; Remote Ata Configuration Commands - Motorola Netopia 7000 Administrator's Handbook

Administrator's Handbook

CONFIG Commands

This section describes the keywords and arguments for the various CONFIG commands.
Remote ATA Configuration Commands
® ®
Motorola Netopia firmware supports configuration of a maximum of four Motorola Netopia ATA pro-
®
files, which are stored in the Gateway's configuration database. When a Motorola Netopia ATA is dis-
covered, the Gateway compares the MAC address of the ATA with one of the existing profiles stored in
®
the database. If there is a match, the configuration is downloaded to the Motorola Netopia ATA, and
®
the ATA is restarted. Once the Motorola Netopia ATA is restarted, it comes up with the newly down-
loaded configuration.
set ata profile [ 0... 3 ] ata-option [ on | off ]
Enables or disables the remote ATA configuration option for the specified ATA configuration profile to be
stored in the Gateway.
set ata profile [ 0... 3 ] ata-mac-addr MAC_addr
Specifies the MAC address of the ATA for the specified configuration profile.
set ata profile [ 0... 3 ] ata-qos-enable [ on | off ]
Enables or disables QoS for the specified profile.
set ata profile [ 0... 3 ] ata-dhcpc-enable [ on | off ]
Enables or disables DHCP client service for the specified profile.
set ata profile [ 0... 3 ] ata-dhcpc-hostname string
Specifies a DHCP client hostname for the specified profile.
set ata profile [ 0... 3 ] ata-dhcpc-vid-enable [ off | on ]
Enables or disables a DHCP client vendor ID for the specified profile.
set ata profile [ 0... 3 ] ata-dhcpc-vid string
Specifies a vendor ID for the specified profile when ata-dhcpc-vid-enable is on.
set ata profile [ 0... 3 ] ata-static-wan-ip ip_addr
Specifies a static WAN IP address for the specified profile.
set ata profile [ 0... 3 ] ata-static-wan-subnet-mask subnet_mask
Specifies a static WAN IP subnet mask for the specified profile.
148