Motorola Netopia 7000 Administrator's Handbook page 152

Administrator's Handbook
set bridge concurrent-bridging-routing {on | off }
Enables or disables Concurrent Bridging/Routing.
set bridge dhcp-filterset " string "
Assigns a filterset named string to the bridge configuration.
NOTE:
A filterset can only be configured for the bridge if the system bridge or concurrent bridging/
routing is enabled.
set bridge ethernet option { on | off }
Enables or disables bridging services for the specified virtual circuit using Ethernet framing.
set bridge dsl vcc n option { on | off }
Enables or disables bridging services for the specified interface. Specified interface must be part of a
VLAN if bridge is turned on. Only RFC-1483 Bridged encapsulation is supported currently.
K show log command will show that WAN Bridge is enabled when at least one WAN interface is
bridged.
K show ip interfaces and show bridge interfaces commands will show the interfaces that are not in
bridged mode and that are in bridged modes, respectively.
set bridge table-timeout [ 30 ... 6000 ]
Sets the timeout value for bridging table timeout. Default = 30 secs; range = 30 secs – 6000 secs (.5–
100 mins).
152