Table of Contents
Advertisement
DCS-VIP Internet Keyphone
Installing VoIP Option Card
Installing VoIP Option Card
Refer to the installation instructions supplied with your card for full details on installing the card.
The basic steps are as follows.
1. Switch off the unit and disconnect the power cord.
2. Remove the cover by releasing the screws at the rear and lifting it off the base unit.
3. Install the VoIP option card in the dedicated position on the main board of the base unit.
4. Replace the cover and screw into place.
5. Connect the power cord and switch on.
6. Run MMC 724 (Dial Numbering Plan) to assign the new port numbers.
Programming VoIP Op p tions
Programming VoIP O
First plan your network. You need to know the IP addresses of all the other destinations and
what IP address you are going to give to your own VoIP card. Refer to the example network dia-
gram above.
In this example, we have six sites with the following IP addresses:
Site 1. 107.214.29.41 STL Oxford Gateway
Site 2. 107.214.29.42 STL Oxford Gateway (Test)
Site 3. 107.214.29.40 STL Oxford VIP
Site 4. 107.214.28.40 STL Manchester Gateway
Site 5. 107.11.3.48
Site 6. 222.87.14.18 LSP Australia VIP IP 168.219.73.149
The following conditions apply:
Access codes correspond to the site number; i.e. site 1 will be accessed if 100 is dialled, site
•
2 will be accessed if 200 is dialled, and so on.
The Wizard Setup described earlier in this guide for configuring VoIP employs the screens
•
used for the Advanced Setup procedure. For this example the Advanced Setup procedure is
followed rather than the Wizard Setup.
The VIP router being programmed is at site 3 (Oxford VIP).
•
The first screen is for configuring the IP address of the VoIP card. This address is different to the
address of the VIP router.
The second screen is the VoIP Option page.
tions
STL Korea Gateway
— 31 —
Quick Guide
Advertisement
Table of Contents
