Table of Contents
Advertisement
DCS-VIP Internet Keyphone
Set the following parameters.
IP Address: Enter the IP address of the router.
l
Subnet Mask: Enter the subnet mask of the router.
l
Connect To: Select the connection for the DCS-VIP (ISP or Remote Router)
l
ISP Connection: Connect to ISP.
−
Remote Router Connection: Connect to remote routers such as branches and
−
headquarters.
DHCP Server: Choose whether to use the DCS-VIP as a DHCP server.
l
Enable: Select to allocate the IP addresses in the PCs connected to the DCS-VIP.
−
Disable: Select not to use the DHCP function. If you select "Disable", the network
−
administrator should set up network information, including the IP addresses in con-
nected PCs.
ML-PPP (Multilink PPP): ML-PPP is the protocol that combines more than two ISDN B
l
channels into one PPP (128Kbps). Select "Enable" to use the ML-PPP function.
Number of Channels: Select the bandwidth (64K/128K) for the ISDN line. If you select
l
128K, you are using two different B channels at the same time. Thus, phone charges will be
doubled.
Click the Next button.
Router Wizard Setup - - Setup 2
Router Wizard Setup
On this screen you can enter information about the ISP or the remote node to which you are
connecting.
¶ ¶
For ISP Connection
For ISP Connection
If you chose ISP for the Connect To parameter on the Router Wizard Setup - Setup 1 screen,
the following parameters will be displayed.
Setup 2
— 14 —
Quick Guide
Advertisement
Table of Contents
