Table of Contents
Advertisement
DCS-VIP Internet Keyphone
3 3
Configuring Your DCS- - VIP
Configuring Your DCS
After installing the DCS-VIP system, switch it on. Using a PC, run a web browser and connect to
the default system IP address. Run the Wizard Setup on the startup screen of the DCS-VIP to
easily and quickly configure the system. (When configuration is complete, you must save the in-
formation in sys tem flash memory and on the PC's hard disk. This is described in section 4.)
¶
Switching On the System
Switch on the system by pressing the power on/off switch on the rear panel of the DCS-VIP. The
'Run' LED lights green and the system performs a start-up routine. When completed, the Run
LED flashes.
·
Clearing the Memory
Using a digital keyset, program MMC 811 (Reset System) to reset and clear the system memory
via the
CLEAR MEMORY
ual for details).
¸
Connecting to the Web Management Screen
The factory default IP address of the DCS-VIP is "1.1.1.1". To set up the DCS-VIP system, run
the web browser (Internet Explorer 5.0 or later, or Netscape Navigator 4.5 or later, is recom-
mended) and connect to this default IP address.
1. To reset the IP address, subnet mask and gateway of the PC to be used for setting up the
DCS-VIP system, double click the Network icon in the Windows Control Panel. Set each
of the following properties.
IP address : 1.1.1.2
l
Subnet mask : 255.0.0.0
l
Gateway : 1.1.1.1
l
Note
Ensure that the TCP/IP protocol is installed in the PC.
option (see the Samsung DCS-VIP Internet Keyphone Programming Man -
— 8 —
VIP
DCS-VIP router
Quick Guide
Advertisement
Table of Contents
