When Access Key Does Not Operate Properly; Replacing Battery Of Access Key; Replacing Access Key; Certification For Keyless Access With Push-Button Start System - Subaru 2015 Forester Owner's Manual

2-16
Keys and doors/Keyless access with push button start system
7. Within 30 seconds after step 6 is
performed, close and open the driver s
door once.
8. Within 5 seconds after step 7 is
performed, close the door. A chirp sound
will be heard, and the functions will be
disabled.
NOTE
In steps 4 and 6, press the power door
locking switch slowly. If the switch is
pressed quickly, the functions may not
be disabled.
Enabling functions
When the procedure to disable the func-
tions is performed again, the functions are
enabled.
When access key does not
operate properly
Refer to Access key if access key does
not operate properly 9-17.
Replacing battery of access
key
Refer to Replacing access key battery
11-45.

Replacing access key

Access keys can be replaced at SUBARU
dealers. For more details, contact a
SUBARU dealer.
Certification for keyless ac-
cess with push-button start
system
U.S.-spec. models
FCC ID: HYQ14ACX
FCC ID: Y8PSSPIMB02
FCC ID: Y8PSSPLF02
CAUTION
FCC WARNING
Changes or modifications not ex-
pressly approved by the party re-
sponsible for compliance could void
the user s authority to operate the
equipment.
NOTE
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions: (1) This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received, in-
cluding interference that may cause
undesired operation.
Canada-spec. models
NOTE
This device complies with Industry
Canada licence-exempt RSS standard
(s). Operation is subject to the follow-
ing two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
NOTE
Le présent appareil est conforme aux
CNR d Industrie Canada applicables
aux appareils radio exempts de licence.
L exploitation est autorisée aux deux
conditions suivantes: (1) l appareil ne
doit pas produire de brouillage, et (2)
l utilisateur de l appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d en compromettre le fonctionnement.