Subaru 2015 Forester Owner's Manual page 210

Hazard warning flasher setting
1. Perform the preparation steps accord-
ing to Preparation for car settings
2. Operate the or
select the Hazard Warning Flasher item.
Then pull the /SET switch toward you.
3. The current setting will be displayed.
Pull the /SET switch toward you to
3-71. enter the selection mode.
switch to 4. Select On or Off by operating the
or switch. Then pull the
switch toward you.
Instruments and controls/Multi function display
5. Select Set by operating the
switch, and confirm the setting by pulling
the /SET switch toward you.
6. The system will notify you that the
/SET setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
3-73
CONTINUED