Sensor (Stapler Pass Through) Static Jam Service Check; Sensor (Output Pass Through) Late Jam Service Check - Dell 5535dn Service Manual

Sensor (stapler pass through) static jam service check

Step
1 Check the media path for partially fed or jammed media.
Is the media path free from partially fed or jammed media?
2 Check the sensor (stapler pass through) for proper
operation.
1. Enter the diagnostic mode
2. Select Finisher sensor test
3. Select Sensor test
4. Select pass & media
5. Observe the line item "passthru"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
3 Check the above sensor for proper connection.
Is the above sensor connected properly?

Sensor (output pass through) late jam service check

Step
1 Check the output option for proper installation.
Is the above component properly installed?
2 Check for obstructions in the media path between the base
machine and the output option.
Is the media path free from obstructions?
3 Check the sensor (output pass through) for proper
operation.
1. Enter the diagnostic mode
2. Select Output bin tests
3. Select Sensor test
4. Select Output bin x
5. Observe the line item "passthru"
Does the display on the operator panel, change every time
the sensing area of the above sensor is interrupted or
blocked.
4 Check the above sensor for proper connection.
Is the above sensor connected properly?
5 Perform a print test using the output option.
Does the error continue?
Check
Check
Yes
Go to step 2. Remove any pre-
staged or jammed
media.
Go to step 4. Go to step 3.
Replace the output Replace the
option. connection.
Yes
Go to step 2. Remove then
reinstall the output
option
Go to step 3. Remove
obstructions.
Go to step 5. Go to step 4.
Replace the Replace the
sensor (output connection.
pass through).
Go to "4-bin
mailbox
assembly sensor
(pass through)
removal" on
page 4-232.
Replace the output Problem solved.
option.
Diagnostic information
No
No
2-145