Dell 5535dn Service Manual page 48

Error
code or
message
201.06
201.07
201.25
201.26
201.27
201.29
201.30
2-16
Service Manual
Error contents
Sensor (narrow
media) late jam
Type 1 fuser
Sensor (fuser output)
late jam
Type 1 fuser
Sensor (fuser output)
area jam.
Type 2 fuser
Main drive motor
assembly load error.
Type 2 fuser
Sensor (fuser output)
late jam.
Type 2 fuser
Sensor (narrow
media) late jam
Type 2 fuser
Operator panel door
assembly interlock
switch failure
Type 2 fuser
Description/Action
The expected wide media is
late reaching the sensor
(narrow media) within the
specified time.
The media is late reaching the
sensor (fuser output) within the
specified time.
The media is jammed in the
sensor (fuser output) area.
The main drive motor assembly
has failed or caused high
mechanical load due to paper
jam or bind.
The media is late reaching the
sensor (fuser output) within the
specified time.
The expected wide media is
late reaching the sensor
(narrow media) within the
specified time.
The printer detected that the
operator panel door interlock
switch did not cycle prior to
printer restart.
Possible repair actions
Go to sensor (narrow media)
late jam service check.
See "Sensor (narrow media)
late jam service check" on
page 2-135.
Go to sensor (fuser output) late
jam service check.
See "Sensor (fuser output)
late jam service check" on
page 2-132.
Go to sensor (fuser output)
service check.
See "Sensor (fuser output)
late jam service check" on
page 2-132.
1. Check all connections on
the main drive motor
assembly.
2. Check all connections on
the system card assembly.
3. Replace the main drive
motor assembly if problem
remains. Go to "Main drive
motor assembly removal"
on page 4-20.
Go to sensor (fuser output) late
jam service check.
See "Sensor (fuser output)
late jam service check" on
page 2-132.
If problem remains, a type 2
fuser can be installed.
Go to sensor (narrow media)
late jam service check.
See "Sensor (narrow media)
late jam service check" on
page 2-135.
1. Remove all media present
in media path.
2. Ensure that the operator
panel door assembly is fully
open then fully closed.
3. Check operator panel door
assembly for damage.
4. Check interlock switch (in
left operator panel hinge)
for damage.
5. Check all connections on
the system card assembly.