Chapter 12 Parameters And Defaults - Denso GT10Q-SU User Manual

Chapter 12 Parameters and Defaults

The tables below list the parameters and their default values. You can change them using the QR-coded parameter
menu or configuration software (ScannerSetting_2D). Note that shadowed parameters can only be set in the
configuration software (ScannerSetting_2D).
When the scanner leaves the factory, all of these parameters are set to defaults.
(1) Interface to the host
Items
Interface
(Note 1) Selecting the USB keyboard interface disables the configuration software.
(2) Communications parameters for USB-COM interface
The following settings take effect only when the USB-COM interface is set up.
Items
Communications protocol
Header
Terminator
Transmission of BCC
CTS signal control
CTS signal timeout
ACK/NAK response time
Parameters
USB-COM interface
USB keyboard interface
(See Note 1.)
Parameters
Non-acknowledge mode
ACK/NAK mode
None
STX
ETX
CR
LF
CR LF
Enable
Disable
Yes
No
0.1 to 9.9 seconds
0.1 to 9.9 seconds
: Can be changed only with the configuration software.
61
Defaults Refer to:
√
Chapter 10
Defaults Refer to:
√
Section 10.1
√
Section 10.3, (1)
√
Section 10.3, (3)
√
Section 10.1
√
2 s
Section 10.1
1 s