Delimited-Text Format Conversion Mode - Denso GT10Q-SU User Manual

8.2.2 Delimited-text format conversion mode

In this mode, the scanner splits data read from the code specified by "Code type" at the positions of commas, CRs,
LFs, CRLFs and TABs contained in the data and outputs it in the data transmission format selected in the scanner
(see Chapter 10, Section 10.3).
Conversion conditions
Conversion conditions
"Code type"
"Data transfer regardless of error result"
Example Code read: PDF417, Data: 12,34[CR]56[TAB][CR]78,
Code ID mark: Disable, Header: STX, Terminator: ETX,
Transmission of the number of digits: Disable, BCC: Disable, Prefix/Suffix: None
Conversion conditions
"Code type": PDF417
"Data transfer regardless of
error result": Prohibit or
Permit
"Code type": QR Code
"Data transfer regardless of
error result": Prohibit
"Code type": QR Code
"Data transfer regardless of
error result": Permit
Note: In the case of multi-line bar codes, unless all code ID marks read are matched, the data editing process will
result in an error regardless of whether or not the data read contains any error. Whether the code ID mark is matched
is determined not by the combination of code ID marks Type 1 and Type 2 but by Type 1 only (refer to Chapter 10,
Section 10.3).
Choices
Any code
QR Code
PDF
Data Matrix
MaxiCode
UPC-A/EAN-13
UPC-E
EAN-8
Code 128
EAN-128
Codabar (NW-7)
Code 39
Interleaved 2of5 (ITF)
RSS
EAN.UCC Composite symbology
Permit/Prohibit
[STX]12[ETX][STX]34[ETX][STX]56[ETX][STX][ETX][STX]78[ETX]
Error
[STX]12,34[CR]56[TAB][CR]78[ETX]
41
Output data