Denso GT10Q-SU User Manual page 27

Windows XP
(1) Switch the computer on to run Windows XP. Log on as an Administrator.
(2) Connect the scanner interface cable to the computer or USB hub.
(3) Wait for the Found New Hardware hint to pop up on the
Windows task tray.
Windows will automatically configure the scanner. Upon
completion of the configuration, the screen shown at left
automatically disappears.
(4) To check whether the USB device is working normally,
open Windows' Device Manager.
If USB Human Interface Device is added to the sub-tree of
Human Interface Devices as shown at left, the scanner is
connected normally.
If the device is not added or it is marked with
remove this driver with the uninstaller, reboot your
computer, and perform the above connection process again.
18
or ,