Table of Contents
Advertisement
Chapter 10 Parameters and Defaults
The tables below list the parameters and their defaults. Those parameters can be changed with the QR-coded
parameter menu or configuration software (ScannerSetting_2D), except shadowed ones only with the configuration
software.
When the scanner leaves the factory, all of these parameters are set to defaults.
(1) Reading mode related parameters
Items
Data edit
Period of double-read prevention
(2) Interface to the host
Items
Interface
(Note 1) Selecting the USB keyboard interface disables access to the configuration software (ScannerSetting_2D).
(3) Communications parameters for USB-COM interface
The following settings take effect only when the USB-COM interface is set up.
Items
Communications protocol
CTS signal monitoring
CTS signal monitoring time
ACK/NAK confirmation time
Parameters
Non-edit mode
Data extraction mode
Data conversion (substitution)
mode
Data blocksorting mode
ADF script mode
Double-read enabled
Period of double-read prevention
0.1 to 9.9 seconds
Parameters
USB-COM interface
USB keyboard interface (Note 1)
Parameters
Non-acknowledge mode
ACK/NAK mode
With CTS signal Monitoring
No CTS signal Monitoring
0.1 to 9.9 seconds
0.1 to 9.9 seconds
54
Defaults
0.5 s
: Can be changed only with the configuration software.
Defaults
Defaults
2 s
1 s
: Can be changed only with the configuration software.
Refer to:
Section 7.1
Chapter 4
Refer to:
Chapter 2
Refer to:
Section 9.1
Advertisement
Table of Contents
