Denso GT10Q-SU User Manual page 7

To System Designers:
• When introducing the scanner in those systems that could affect human lives (e.g., medicines
management system), develop applications carefully through redundancy and safety design
which avoids the feasibility of affecting human lives even if a data error occurs.
• If smoke, abnormal odors or noises come from the scanner, immediately switch off the host
computer, unplug the interface cable, and contact your nearest dealer.
Failure to do so could cause fire or electrical shock.
• If foreign material or water gets into the scanner, immediately switch off the host computer,
unplug the interface cable, and contact your nearest dealer.
Failure to do so could cause fire or electrical shock.
• If you drop the scanner so as to affect the operation or damage its housing, switch off the host
computer, unplug the interface cable, and contact your nearest dealer.
Failure to do so could cause fire or electrical shock.
• Never bring any metals into contact with the terminals in connectors.
Doing so could produce a large current through the scanner, resulting in heat or fire, as well as
damage to the scanner.
• Never use the scanner on the line voltage other than the specified level.
Doing so could cause the scanner to break or burn.
• Do not use the scanner where any inflammable gases may be emitted.
Doing so could cause fire.
• Do not subject the scanning window of the scanner to direct sunlight for extended periods.
Doing so could damage the scanner, resulting in a fire.
• The scanner uses a laser light for indicating
the scan range. The intensity of laser light
might be too low to inflict bodily injury.
However, do not look into the laser beam.
The scanner complies with IEC
60825-1:1993+A2:2001 and 21 CFR
1040.10, 1040.11 except for deviations
pursuant to Laser notice No. 50, dated July
26,2001.
In accordance with Clause 5, IEC 60825-1,
the following information is provided to the
user:
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
Caution – Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous laser light exposure.
iii