Chapter 8 Scanning Functions; Data Verification Mode; Verification Setup Procedure - Denso GT10Q-SU User Manual

Chapter 8 Scanning Functions

8.1

Data verification mode

The data verification mode verifies the code data read against the master data stored in the scanner and reports the
match status with data output. You can set the verification parameters with the configuration software
(ScannerSetting_2D).
There are two ways to register master data--"Preset master registration" and "Scanning master registration." The
former refers to registration that you make with the configuration software (ScannerSetting_2D) in advance; the latter
can be made by scanning a code label.

8.1.1 Verification setup procedure

(1) Preset master registration
Register the code type and data to be used for verification using the configuration software (ScannerSetting_2D). Up
to 99 digits can be registered. The registered data will be sent to the host computer when you scan the "Output master
data code" given on page 28.
The registered master data will be preserved even if the scanner is turned off. To clear it, first clear the registered
master data stored in the host computer with the configuration software (ScannerSetting_2D) and then send the new
setting data to the scanner.
(2) Scanning master registration
Scan a code to be registered as master data in the following way:
1) Place the scanner in the data verification mode and hold down the magic key for approx. 2 seconds. (The
indicator LED should light in green.)
2) With the magic key held down, press the trigger switch to read the master code to be registered. (The scanner
operates in the trigger switch operating mode currently set.)
During the registration operation above, if the master data has fewer characters than specified (e.g., less than the
specified verification start position), the registration operation aborts with an error.
Even if "Preset master registration" has been made, you can make "Scanning master registration." If both "Preset
master registration" and "Scanning master registration" have been made, the number of characters to verify that has
been set with the "Preset master registration" and the master data that has been set with the "Scanning master
registration" will be valid.
The registered data will be sent to the host computer when you scan the "Output master data code" given on page 28.
Note: The registered master data will be cleared when:
- the scanner is turned off,
- you change the parameters of the verification start position or the number of characters to be verified, or
- the verification conditions are updated with the configuration software (ScannerSetting_2D), by scanning a
batch-process QR Code printout, or by scanning the QR-coded parameter menu.
Note: You can register a code as master data any number of times as long the indicator LED is lit in green by pressing
the magic key. The code that is read last becomes the final master data.
Note: If no master data has been entered by either the preset master entry or scanning master entry, the indicator LED
flashes in red, during which it is impossible to scan codes.
26