Section 3
Basic Knowledge of Operation
Communication Data Format
This section explains the format of communication between the reader and upper equipment.
Upper equipment
Inputting a reading trigger using an RS-232C command
The reading trigger command format is as shown below.
The continuous reading trigger command format is as shown below.
The continuous reading stop command format is as shown below.
Note: If a non-existent command is received, ER+CR(ODH) is returned.
Inputting a setting command
The reading condition setting command can be transmitted from the upper equipment.
The format is as follows.
For details about the commands, refer to Section 4.
p.58
V400-R2 series
52
User's Manual
Input command
Reading data output
MEASURE
CR
(0DH)
MEASURE /C
CR
(0DH)
CR
MEASURE /E
(0DH)
Command
Multi-code reader
V400-R2 series
or
or
STX
Z
(02H)
(03H)
or
M
CR
(0DH)
or
M /C
CR
(0DH)
or
CR
M /E
(0DH)
ETX
or
GC
CR
(0DH)
or
CR
SC
(0DH)