Wiring And Connection - Omron V400-R2 Series User Manual

Wiring and Connection

This section explains the pin arrangement, the input/output circuit, and the method of
connection to upper equipment.
Pin arrangement and input/output circuit
Pin arrangement
Connection with upper equipment p.33, p.34
Wire color Pin No. Signal name
Green 1
White 2
Gray 3
Blue 4
Brown 5
- 6
Black 7
Red 8
Yellow - (Note)
Orange - (Note)
When you make a connection cable, use the following connectors.
Recommended parts for the connector
Usage
For cable relay
For panel installation
The OK and NG output lines are not connected to the DIN 8-pin connector. To use the OK and NG
outputs, cut the cables.
Input/output circuit
Connector part (DIN: 8P plug)
Made by Hosiden Corporation
TCP1394-715267 (Type A)
Function
SD Transmission data
RD Received data
RS Transmission request
CS Transmission allowed
TRIG External trigger signal
NC Not connected
S.GND 0 V
VCC Power supply
OK READ OK output
NG READ NG output
Manufacturer
Hosiden Corporation
Hosiden Corporation
Introduction Procedure
(Pin alignment)
Signal direction
Reader
External
Model
TCS8587-0170477
TCS1080-0120177
Section 2
Upper equipment
External
External
External
V400-R2 series
31
User's Manual