Number Of Digit Output - Omron V400-R2 Series User Manual

Section 4
Setting Method

Number of digit output

Whether to output the number of digits to the data output format is specified.
This setting item can be registered as 1 item of the header and is added to a location
determined by the order of registration.
Two-byte characters are handled as 2 characters in 2D codes.
Set "Clear the header (PR)" to clear the number of digit output.
E.g.: The following describes the steps for setting the number of digit output.
Number of digit output
(Bar code: 2 digits, 2D code: 6 digits)
Number of digit output
(Bar code and 2D code: 6 digits)
The output format is as shown below.
• When the the number of digits output is set to [ZZRY$3ZZ] (barcode 2 digits), the number of digits is
• When the number of digits output is set to [ZZRY$6ZZ] (barcode 6 digits), the number of digits is
V400-R2 series
86
User's Manual
Set the headers collectively (RY)
Output the number of digits ($3)
Menu sheet
_$3_
_$6_
"05" when the data of the barcode of the scanned code is "ABCDE".
"000005" when the data of the barcode of the scanned code is "ABCDE".
Setting start (ZZ)
Setting end (ZZ)
Command
$3
$6