Section 2
Introduction Procedure
Introduction Flow Chart
A flow chart of preliminary examination, installation, and introduction of the product is as
shown below.
Preliminary
examination
Wiring and
connection
Preparation
V400-R2 series
22
User's Manual
Check the type, width, height, and the number of digits of 2D codes
and bar codes.
p.24 Supported code list
p.27 Reading range performance
p.29 Reading angle performance
Complete wiring.
p.31 Pin arrangement and input/output circuit
Connect peripheral equipment.
p.33 Example of connection with a PC
p.34 Example of connection with programmable controller (CS1)
Turn on the power switch.
Press the SCAN button to check whether
the code is read.
p.37 Testing
Investigate the reading timing.
p.38 Investigation into the reading timing
p.46 Basic operation flow chart
Set the reading condition corresponding to the purpose.
p.39 Setting the reading conditions
p.58 Menu Sheet/Command List