Enabling Wi−Fi From User Home Screen - Lennox icomfort Wi?Fi Thermostat Owner's Manual

Enabling the thermostat's Wi-Fi feature from the Home screen
network security key or passphrase
displays information here as keys pressed
WI−FI SETTINGS
Wi−Fi
disable
7 END
1
START
HERE
Wi−Fi
1
press any line to edit it
network name (SSID)
6
press here to enter network name
password
6
press here to enter Wi−Fi AP (router) password
7 END
connect
type the network security key or passphrase for
(locked Wi−Fi Access Point [AP])
6
press here to enter Wi−Fi AP (router) password
7 END
connect
NETWORK SETTINGS
5.0
5.0 UNSECU-
RED ACCESS
POINT
5?
WI−FI SETTINGS
4
Wi−Fi
NETWORK
enable
SETTINGS
2
Figure 22. Wi−Fi setup
Page 17
Secure Connection Recommended!
Make sure the router is capable of, and set to operate
5.2 none
in wireless network b" mode. Check router utility
security
WEP
WEP
program or contact service provider for help. A se-
is WPA2
cure wireless network is recommended over an open
5.2
WPA
WPA
(unsecured) network. You will need the homeowner's
a
approval and router password to enable Wi−Fi in a se-
WPA2
WPA2
cured connection.
Enable Wi−Fi
communicate with a wireless router:
1. Press and release Wi−Fi" in the lower left corner of the
HOME screen (see START HERE). The screen
changes from the Home Screen to the WI−FI SET-
TINGS screen.
2. Press the Wi−Fi enable button.
3. Press next as necessary; then press accept after
reading the User Agreement.
5.1
4. Press NETWORK SETTINGS; this screen shows a
graphical view of buttons representing Wi−Fi options
OPEN and SECURE wireless networks and a button
5.2
for creating a new access point (AP).
5.1 SECURE
5. Decide which of these buttons you need to select:
Access Points
5.0 OPEN Wi−Fi Port (no password required).
5.1 SECURE Ports (requires router password).
5.2 Create new AP (Access Point).
5.2 CREATE NEW AP
5.2a When creating a new AP, you have the option
of selecting a security level (default is none; choose
User Agreement
from WEP, WPA, WPA2, depending on the security
defined in the homeowner's router); the password field
appears.
next...
6. When you touch in one of the input fields (press here
next...
to enter...), the keyboard tool appears. Enter password
3
(if simply logging into an existing network) or enter the
accept decline
network name if creating a new AP. If you mistype the
password or if you cannot access the selected net-
work, a message will alert you to retry.
7. Press connect to complete the connection. Note that
changes to Wi−Fi disable".
icomfort Wi−Fit 7−Day Programmable Communicating Thermostat
To enable the Wi−Fi feature to
Wi−Fi enable" button on the Wi−Fi SETTINGS screen