Registering Icomfort Wi−Fit From User Home Screen - Lennox icomfort Wi?Fi Thermostat Owner's Manual

Register the icomfort Wi−Fitthermostat
From NETWORK SETTINGS screen, you can change to the desired net-
work as shown in figure 23. Enter security key or passphrase. X" back to the
WI−FI SETTINGS screen.
NOTE NETWORK's marked with * - Selecting one of these
wireless networks may result in an unreliable connection to
your thermostat. Press help ?" for tips on improving signal
strength.
choose a wireless network
NETGEAR NETWKB NETWKC
type the network security key or passphrase for
NETGEAR
dis−
Wi−Fi
connect
9:39 am January 23, 2012
Figure 23. Change Networks
Registration for online access
From the WI−FI SETTINGS screen, press the thermostat not registered"
button (see figure 24).
Enter homeowner email address twice and press the register button.
A pop up screen then appears to notify the user to check their home comput-
er for instructions to complete the registration. After the server sends the
email with the network link, registration and account creation must be com-
pleted on the homeowner's personal computer (see Page 19).
506921−01 09/12
(returns to
NETWKD *
WI−FI SETTINGS
screen)
add new
network
AP Info
NOTE − Time from pushing the registration button on the thermostat and re-
ceiving the consumer portal register link from your email on your computer is
from 5 to 15 minutes.
After registration has been completed, any available firmware downloads
will immediately start downloading to the thermostat.
REGISTRATION
enter your email
re−enter your email
System Desc
WI−FI SETTINGS
Wi−Fi
9:39 am January 23, 2012
connected
press to
change network
settings
NOTE −
If any downloads are available for the thermostat they will start downloading
Connection to server has not bee established or it has been lost. Please
right away. When new firmware is being downloaded or when Gelaskins are
being installed, the thermostat screen will temporarily go blank and running
Wi−Fi
9:39 am January 23, 2012
units may cease operation while the system is being reset to accommodate
the new changes. This is normal and can last a couple minutes.
Figure 24. Registering the system for online access
For any issues with Wi−Fi connections, refer to Wi−Fi Troubleshooting
Checklist 507037−01.
Page 18
Register with iComfort thermostat to enable remote access and
online weather information
register
(returns to
screen)
thermostat Firmware
Wi−Fi not update
enabled registered auto
press to enable press to change press to toggle firm-
/ disable Wi−Fi thermostat regis- ware update between
tration auto" and off"
wait until a connection is established.
HOME