Start Up - Lennox icomfort Wi?Fi Thermostat Owner's Manual

Start up

In event of power failure
If a power failure occurs,
when the power comes back on, the thermostat will reboot
and when complete, the HOME screen will return.
What the Home screen tells you...
After the thermostat and the
system has been fully connected
and powered on, the icomfort Wi−Fit
thermostat's Home screen is
displayed. Figure 1 shows a
display and describes what the
thermostat is telling you.
Note that set to heat or cool
communicates that the system
is operating in manual mode;
if it were in program mode,
the heat or cool button would
read summer program is on
(or other named program).
Other information...
Until and unless the indoor temperature
is at or between the two settings
(70 to 75 degrees in this example), the system
should run until it does measure within that
temperature range.
Wi−Fi" in the bottom lift corner is the button" to access
the Wi−Fi settings screen. Wi−Fi with a
a prior connection to the server has been lost. If a connection had
been lost, then re−established, the triangle goes away.
Away mode sets the thermostat for energy saving while you are gone for an
extended period of time. In this mode, the system will only come on if indoor
temperature falls below 62 degrees (for heating) or if indoor temperature rises
above 85 degrees (for cooling).
heat−to setting cool−to setting
indoor
temperature indoor temperature
indoor
humidity
(if feature
is
turned on)
indoor humidity is 41%
system status
Wi−Fi setup
system is cooling
button
Wi−Fi 9:39 am January 23, 2012
time, month, day, year
Figure 1. Home screen (typical)
beneath it indicates
What you can do from the Home screen...
(if feature is turned on)
system mode
outdoor temperature
outdoor
set temp temperature
80
75 heat
or
cool
cool−to
70
fan is
AUTO
fan is fan is
press to go
heat to
AUTO OFF
use arrows
to change
temperature
?
service alerts are present
Adjusting the humidity, even if no physical humidifier or
dehumidifier is present, may also be available, provided the
icomfort Wi−Fit 7−Day Programmable Communicating Thermostat
Page 3
Typically, what every homeowner wants from an air
conditioning system is to be able to control that
system using a convenient device to
adjust heating, cooling, and the
level of humidity in the home.
From this screen you may:
away
mode
− adjust temperature
settings
− access menus to change the
program mode
− change how the
to user
fan operates
dashboard
− access the dashboard" (fig.
fan is set
3) by pressing
to AUTO
− access and view active ser-
vice alerts by pressing the
icon
− access help screen by press-
ing the ?" icon.
Adjusting the temperature and changing the
system mode of operation is described fully
installer has implemented the feature during setup.
See Page 16 for details on humidity control.
beginning on Page 14.