7.5
SAS expander board
7.5.1
Installing the SAS expander board
Field Replaceable Units (FRU)
Average task duration: 10 minutes
Average task duration including SAS expander spacer bolt:
installation: 40 minutes
7.5.1.1
Required tools
Preliminary and concluding steps: tool-less
●
Installing SAS expander board spacer bolts:
●
– Phillips PH2 / (+) No. 2 screw driver
Installing the SAS expander board: tool-less
●
7.5.1.2
Preliminary steps
Before installing the SAS expander board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page
69.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
TX300 S7 / RX350 S7
139.
70.
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
75.
74.
365