Switching On The Id Indicator; Completing The Maintenance Task; Updating Or Recovering The System Board Bios And Irmc - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY TX300 S7:

Table of Contents

Switching on the ID indicator

When working in a datacenter environment, switch on the ID indicator on the

front and rear connector panels of the server for easy identification.

For further information, refer to section

or to the "ServerView Suite Local Service Concept (LSC)"

Using the ID button on the front panel

Ê Press the ID button on the front panel to switch on the system identification

For further information, refer to section

indicators" on page

Using ServerView Operations Manager

Ê In ServerView Operations Manager Single System View and press the Locate

button in the title bar to switch on the ID indicators.

Updating or recovering the system board BIOS and

After replacing the system board, it is essential to upgrade the BIOS and iRMC

to the latest version. The latest BIOS and iRMC versions are available from the

Fujitsu support internet pages at:

http://ts.fujitsu.com/support/

http://jp.fujitsu.com/platform/server/primergy/downloads/

Fujitsu does not assume responsibility for any damage done to the

server or for the loss of any data resulting from BIOS updates.

TX300 S7 / RX350 S7

(EMEA market)

Upgrade and Maintenance Manual

Basic software procedures

"Locating the defective server" on

"Front panel controls and

(Japanese market)

Primergy rx350 s7