Replacing A 3.5-Inch Hdd Module; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

7.3.8

Replacing a 3.5-inch HDD module

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
V
CAUTION!
Only remove an HDD / SSD module during operation if the drive is
●
not currently being accessed. Observe the indicators on the HDD
module, as described in the "PRIMERGY TX300 S7 / RX350 S7
Server" operating manual".
Under no circumstances should you remove an HDD / SSD module
●
while the system is in operation if you are not sure that the drive is
operated by a RAID controller and belongs to a disk array that is
operating in RAID level 0, 1, 1E, 10, 5, 50, 6 or 60.
An HDD / SSD module can only be replaced during operation in
conjunction with a corresponding RAID configuration.
All HDD / SSD modules (drives) must be uniquely identified so that
●
they can be reinstalled in their original mounting locations later. If this
is not done, existing data can be lost.
7.3.8.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing a 3.5-inch HDD module: tool-less
●
7.3.8.2

Preliminary steps

Before replacing a 3.5-inch HDD module, perform the following steps:
Ê Locate the defective server as described in section
server" on page
Ê When working on a tower server, open the HDD bay cover as described in
section "Removing accessible drive and HDD bay covers" on page
Ê Locate the defective HDD module as described in section
indicators on the front" on page
TX300 S7 / RX350 S7
62.
65.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
"Locating the defective
89.
"Local diagnostic
279