Installing Sas Expander Board Spacer Bolts - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Ê Open the side / top cover as described in section
on page 77 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page 98.
Ê Remove the system fan holder as described in section
system fan holder" on page
7.5.1.3

Installing SAS expander board spacer bolts

I
This step is only necessary if SAS expander board spacer bolts are not
already mounted in the system. Otherwise, please proceed to section
"Installing the SAS expander board" on page
Ê Remove the system board as described in section
board" on page
Ê Remove the system board carrier as described in section
system board carrier" on page
Figure 230: Installing SAS expander board spacer bolts (A)
Ê Locate the four mounting bolts (see arrows).
366
"Removing the side cover" on page 86
77.
386.
810.
104.
Upgrade and Maintenance Manual
"Removing the top cover"
"Removing the system air duct"
"Removing the
365.
"Removing the system
"Removing the
TX300 S7 / RX350 S7
(tower