New Buck Corporation 74 Manual page 32

Non-catalytic unit

Hide thumbs Also See for 74:

Table of Contents

2. After locating the center of the hole install the ceiling support box, chimney flashing and

rain cap. Only use2100° UL 103 HT chimney and parts listed in this manual per the chimney

manufactures instruction .

REFER TO CHIMNEY MANUFACTURER'S INSTRUCTIONS FOR ASSEMBLY AND

DISASSEMBLY OF CHIMNEY PARTS.

TIONS FOR PROPER CLEARANCES TO COMBUSTIBLE AND PROPER AIR SPACING

REQUIRED.

3. Add additional pipe until both of the following are met:

(a) Chimney pipe is 3 feet higher than roof at the point where it penetrates the roof.

(b) Chimney pipe height is at least 2 feet higher than any part of the roof within 10 feet of

the chimney. (See Figure 12A. Page 27.)

4. Using only double wall chimney connector listed in this manual (See Page 17), connect the

heater to the chimney by following chimney manufacturer's installation instructions

exactly. (See Figure 13.)

COLLAR

3 SHEET METAL SCREWS

CAUTION

BE SURE TO FOLLOW CHIMNEY INSTRUC-

ROOF

CEILING

Figure 13

Page 28

3 SHEET METAL SCREWS OR RIVETS

Table of Contents

Chapters

Table of Contents