Chapter 3: Mount The Device; Before You Install The P333R-Lb In A Rack - Avaya P333R-LB Quick Start Installation Manual

Chapter 3: Mount the Device

You can mount the P333R-LB in a rack.
The P333R-LB chassis fits in most standard 19-inch racks. It is 2U (3.5", 88 mm) high.

Before you Install the P333R-LB in a Rack

Disconnect all cables from the unit before proceeding with the rack installation.
●
When installing P333R-LB in a rack, ensure that the equipment is positioned such that it
●
will not cause the rack to become unstable or tip over.
Ensure that the combination of equipment in the rack will not cause an overload or
●
overcurrent condition on the power strip being used and/or the customer's branch circuit.
The P333R-LB units weigh a maximum of 15 pounds (6.8 kg). Be careful when installing or
●
removing the P333R-LB product from the rack.
If a power strip is being used in the rack, ensure that it has a reliable earth connection. If
●
the P333R-LB equipment will be plugged directly into a wall outlet, ensure that there is a
reliable ground connection at the outlet.
Ensure that the internal rack ambient temperature is within the operating specification
●
limits of the P333R-LB.
Ventilation for the P333R-LB is from side to side. Ensure that there is adequate space on
●
each side of the P333R-LB equipment when installed in the rack to allow sufficient airflow.
Place the P333R-LB in the rack as follows:
Note:
The P333R is used to illustrate this procedure which is the same for the
Note:
P333R-LB switch.
1. Snap open the hinged ends of the unit's front panel to reveal the screw holes. Refer to
Figure 2
Figure 2: Closed hinged end
Figure notes:
and Figure 3.
P333R
51 52 53 54 55 56 57 58 1 2 3 4
EXPANSION
SLOT
59 60 61 62 63 64 65 66 13 14 15 16
LNK COL Tx Rx FDX FC Hspd
FIV
1
5 6 7 8 9 10 11 12
17 18 19 20 21 22 23 24
ROUT
LAG SYS OPR PWR
LAG
1 2 3
13 14 15
LAG LAG
4 5 6 7 8 9 10 11 12
16 17 18 19 20 21 22 23 24
Issue 1 September 2005
CONSOLE
17