Establishing A Telnet Connection - Avaya P333R-LB Quick Start Installation Manual

Prepare for Configuration
- This returns you to the Router (configure)# prompt
10. If the management station is not on the same subnet as the switch proceed to step 11,
otherwise skip to step 12
11. Configure a default gateway (static route) by typing ip default-gateway
<ip-address> and pressing Enter, replacing <ip address> with the IP address of the
default gateway.
12. Save the configuration changes by typing copy running-config
startup-config and pressing Enter
- The word done is displayed.
Once you have assigned an IP address/interface to the Avaya P333R-LB, you can either
configure it using the Avaya P330 Manager or continue using the CLI.

Establishing a Telnet Connection

Perform the following steps to establish a Telnet connection to the P333R-LB for configuration
of Stack or Router parameters. You can Telnet the Stack Master IP address:
1. Connect your station to the network.
2. Verify that you can communicate with the Avaya P333R-LB by pinging the IP of the Avaya
P333R. If there is no response using ping, check the IP address and default gateway of
both the Avaya P333R and the station.
Tip:
The Avaya P333R-LB default IP address is 149.49.32.134 and the default subnet
Tip:
mask is 255.255.255.0.
3. From the Microsoft Windows taskbar of your PC click Start and then Run (or from the
DOS prompt of your PC), then start the Telnet session by typing: telnet
<P333R_IP_address>
For example: telnet 149.49.32.134
4. If the IP Address in the Telnet command is the IP address of the stack, then connection is
established with the Switch CLI entity of the Master module.
The "Welcome to P333R-LB" screen appears
●
5. Enter the default name root at the Login name prompt.
6. Enter the User Level password root in lower case letters (do not use uppercase letters) at
the Password prompt.
The User level prompt will appear when you have established communications with
●
the Avaya P333R-LB.
You can now configure the stack and change its IP address.
26 Quick Start for Hardware Installation: P333R-LB Stackable Switch