Dipstick - Mercedes-Benz Sprinter Operator's Manual

– 1.0 qts – 1.0 qts Add the amount of oil
X
shown (
– 1.5 qts – 1.5 qts
Check the engine oil level
X
– 2.0 qts – 2.0 qts again after a few minutes.
HI HI The oil level is too high.
Have excess oil removed.
X
Measurement units in the display:
qts qts USA only
R
ltr ltr Canada only
R
Display message for vehicles with steer-
ing-wheel buttons: the display may show
the following messages after the engine oil
level measurement.
1
Action
Do not add oil.
Engine Engine
X
oil level oil level
OK OK
Engine Engine Add the amount of oil
X
shown (
oil Add oil Add
1.0quart 1.0quart
Check the engine oil level
X
again after a few minutes.
Engine Engine
oil Add oil Add
1.5quart 1.5quart
Engine Engine
oil Add oil Add
2.0quart 2.0quart
Engine Engine The oil level is too high.
oil level oil level
Have excess oil removed.
X
Reduce Reduce
oil level oil level
Eng. oil Eng. oil Turn the key to posi-
X
lev. Turn lev. Turn tion 2 in the ignition lock.
ignition ignition
on for on for
level level
page 254).
Y
page 254).
Y
Engine compartment
Observe Observe Repeat the engine oil
X
wait. wait. measurement after about
period period 5 minutes if the engine is
at normal operating tem-
perature.
Repeat the engine oil
X
measurement after about
30 minutes if the engine
is not at normal operating
temperature.
Engine Engine Switch off the engine and
X
oil level oil level wait for approximately
5 minutes if the engine is
Not when Not when
at normal operating tem-
eng. run‐ eng. run‐
ning ning perature. Then, perform
the engine oil measure-
ment.
Measurement units in the display:
qts qts USA only
R
ltr ltr Canada only
R
Checking the oil level using the oil dip-
stick
253
Z