Power Washer - Mercedes-Benz Sprinter Operator's Manual

Care
268
! Make sure that:
the side windows and the roof are com-
R
pletely closed
the climate control blower is switched off
R
the windshield wiper switch is at position
R
0
The vehicle could otherwise be damaged.
You can wash the vehicle in an automatic car
wash from the very start.
Wash off excess dirt before cleaning the vehi-
cle in an automatic car wash.
After putting the vehicle through an auto-
matic car wash, wipe off wax from:
the rear view camera lens (
R
the windshield
R
the windshield wiper blades
R
This will prevent smears and reduce wiping
noises caused by residue on the wind-
shield.
Washing by hand
In some countries, washing by hand is only
allowed at specially equipped washing bays.
Observe the legal requirements for each indi-
vidual country.
Do not use hot water and do not wash the
X
vehicle in direct sunlight.
Use a soft car sponge.
X
Use a mild cleaning agent, e.g. a car sham-
X
poo approved for use with Sprinter vehi-
cles.
Thoroughly hose down the vehicle with a
X
gentle jet of water.
Do not point the water jet directly towards
X
the air inlets.
Use plenty of water and rinse out the
X
sponge frequently.
Rinse the vehicle with clean water and dry
X
thoroughly with a chamois.
Do not let the cleaning agents dry on the
X
paintwork.
When using the vehicle in winter, remove all
traces of road salt deposits carefully and as
soon as possible.
High-pressure cleaning equipment
G
The water jet from a circular jet nozzle (dirt
blasters) can cause invisible exterior damage
to the tires or chassis components. Compo-
nents damaged in this way may fail unexpect-
edly. There is a risk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced imme-
page 271)
diately.
Y
! Under no circumstances use power wash-
ers in the vehicle interior. The pressurized
water and associated spray produced by
the power washer could cause extensive
damage to the vehicle.
! Observe the minimum distance to be
maintained between the nozzle of the
power washer and object to be cleaned, as
outlined below:
R
R
Keep the water jet moving while cleaning.
To avoid causing damage, do not point the
water jet directly at:
R
R
R
R
R
R
R
WARNING
approximately 2.2 ft(70 cm) when using
round-jet nozzles
approximately 1 ft (30 cm) when using
25°flat-spray jets and dirt blasters
door joints
brake hoses
electrical components
electrical connections
seals
drive train, especially not at the inter-
mediate bearing of the propeller shaft
rear view camera (camera lens and
microphone opening on the bottom)
Keep a minimum distance of
1.6 ft(50 cm).