Identification Plates; Vehicle Identification Number - Mercedes-Benz Sprinter Operator's Manual

magnetic compatibility must be checked and
verified.
If these devices are linked to functions asso-
ciated with resistance to interference, they
must have type approval. This applies to the
device or its interfaces to the vehicle elec-
tronics, e.g. charging brackets.
A telephone or two-way radio to be installed
in the vehicle must be approved. Further
information can be obtained from any
Sprinter Dealer.
For operation of mobile phones and two-way
radios, we recommend connection to an
approved exterior antenna. This is the only
way to ensure optimum reception quality
inside the vehicle and to minimize mutual
interference between the vehicle electronics,
mobile phones and two-way radios.
The transmission output of the mobile phone
or two-way radio may not exceed the follow-
ing maximum transmission output (PEAK):
Frequency range
Short wave
(f < 50 MHz)
4 m waveband
2 m waveband
Trunked radio/Tetra
70 cm waveband
GSM 900/AMPS
GSM 1800
UMTS
Maximum trans-
mission output
(PEAK)
100 W
30 W
50 W
35 W
35 W
10 W
10 W
10 W

Identification plates

Identification plates
Vehicle identification plate with vehi-
cle identification number (VIN)
Vehicle identification plate for vehicles or chassis
on the base of the driver's seat
Open the driver's door.
X
You will see vehicle identification plate :
with the vehicle identification number
(VIN), the paint code and the permissible
weight data.
Example: vehicle identification plate (US vehicles)
Example: chassis identification plate (US vehicles)
319
Z