Juniper JUNOS OS 10.4 Manual page 181

Step-by-Step
Procedure
Results
Copyright © 2012, Juniper Networks, Inc.
set bridge-domains bd101 vlan-id 101
set bridge-domains bd200 vlan-id 200
set bridge-domains bd300 vlan-id 300
set bridge-domains bd500 vlan-id 500
set bridge-domains bd600 vlan-id 600
To configure ERP on CS2:
Configure the trunk interface
1.
to connect CS2 to CS1, and configure the
ge-2/0/8
a VLAN ID list of 100 through 1000:
[edit interfaces]
user@cs2# set ge-2/0/4 unit 0 family bridge interface-mode trunk
user@cs2# set ge-2/0/4 unit 0 family bridge vlan-id-list 100-1000
user@cs2# set ge-2/0/8 unit 0 family bridge interface-mode trunk
user@cs2# set ge-2/0/8 unit 0 family bridge vlan-id-list 100–1000
Enable ERP, specifying the control channels and data channels for
2.
and configure as the ring protection link owner:
ring-2
NOTE: Always configure the
configuring the
[edit protection-group]
user@cs2# set ethernet-ring ring-1 east-interface control-channel ge-2/0/4.0
user@cs2# set ethernet-ring ring-1 east-interface control-channel vlan 100
user@cs2# set ethernet-ring ring-1 west-interface control-channel ge-2/0/8.0
user@cs2# set ethernet-ring ring-1 west-interface control-channel vlan 100
user@cs2# set ethernet-ring ring-2 data-channel vlan [200, 300]
user@cs2# set ethernet-ring ring-2 east-interface control-channel ge-2/0/4.0
user@cs2# set ethernet-ring ring-2 east-interface control-channel vlan 101
user@cs2# set ethernet-ring ring-2 ring-protection-link-owner
user@cs2# set ethernet-ring ring-2 west-interface control-channel ge-2/0/8.0
user@cs2# set ethernet-ring ring-2 west-interface control-channel vlan 101
user@cs2# set ethernet-ring ring-2 west-interface ring-protection-link-end
user@cs2# set ethernet-ring ring-2 data-channel vlan [500, 600]
Configure the routing instance, the bridge domains, and the VLAN IDs associated
3.
with each bridge domain:
[edit bridge-domains]
user@cs2# set bd100 vlan-id 100
user@cs2# set bd101 vlan-id 101
user@cs2# set bd200 vlan-id 200
user@cs2# set bd300 vlan-id 300
user@cs2# set bd500 vlan-id 500
user@cs2# set bd600 vlan-id 600
Check the results of the configuration:
user@cs2> show configuration
interfaces {
ge-2/0/4 {
unit 0 {
to connect CS2 to CS1 and trunk interface
ge-2/0/4
family
east-interface
statement.
west-interface
Chapter 13: Ethernet Ring Protection
statement as with
bridge
ring-1 and ring-2
statement first, before
,
161