Replacing Dram Modules - Juniper J-series Services Router J2320 Getting Started Manual

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
3.
4.

Replacing DRAM Modules

The DRAM installed on the Routing Engine provides storage for the routing and
forwarding tables and for other Routing Engine processes. The design of the Routing
Engine allows you to modify the DRAM configuration by adding DRAM modules to
the system board, or removing DRAM modules from the board.
The DRAM modules are located on the top of the system board, as shown in
Figure 86 on page 190 and Figure 87 on page 191. Two pairs of slots are available for
installing DRAM modules. Installing DRAM modules in slots away from each other
provides better performance than installing them in two adjacent slots.
NOTE: Use only DRAM modules purchased through Juniper Networks specifically for
your model.
Figure 86: J2320 and J2350 DRAM Location
190

Replacing DRAM Modules

Insert the USB storage device into the USB port. If the USB storage device does
not easily slide into the port, it might not be oriented correctly. Turn the USB
storage device upside-down and try again.
To configure the USB storage device with the
see the J-series Services Router Administration Guide.
command,
request system snapshot