Konica Minolta bizhub 200 User Manual page 393

11
4
Touch either [Bit Selec-
tion] or [HEX Selection],
and then specify the set-
ting.
– To specify the bits,
touch [Bit Selection],
touch
sor to the bit to be
changed, press ei-
ther the [0] or [1] key
in the keypad to
specify the bit, and then touch [Enter].
– To specify the hex
value, touch [HEX
Selection], specify
the value by either
using the keypad or
touching [A] through
[F], and then touch
[Enter].
5
To change the setting for a different mode, repeat steps 3 and 4.
6
Touch [Enter] in each screen until the initial screen appears.
7
Turn the machine off, then on again.
Reminder
When turning the main power switch off, then on again, wait about 10
seconds after turning the machine off before turning it on again. The ma-
chine may not operate correctly if it is turned on immediately after being
turned off.
11-52
and
to move the cur-
Utility mode
200/250/350