Konica Minolta bizhub 200 User Manual page 262

Copy paper/original documents
4
Touch [Custom Size].
The Custom Size screen
appears.
? How can the size of paper loaded into the bypass tray be selected?
% For details, refer to "To specify a setting for special paper (Change
Setting)" on page 7-15.
5
Type in the length (X)
and width (Y) of the pa-
per.
– Make sure that [X] is
selected, and then
use the keypad to
type in the length of
side X (between 5.50
and 17.00).
– Touch [Y] to select it,
and then use the
keypad to type in the
length of side Y (between 3.56 and 11.68).
– If "Inch (Fraction)" was selected as the measurement units, touch
[X] or [Y] to position the cursor in the input box, and then touch
– A value outside the allowable range cannot be entered.
– To change the entered value, press the [C] (clear) key, and then en-
ter the correct value.
Can paper sizes be stored?
?
% Two specified non-standard paper sizes can be stored. For details,
refer to "To store a non-standard paper size (Custom Size settings)"
on page 7-12.
% To recall a stored paper size, touch [1] or [2].
6
Touch [Enter].
The Paper screen appears again.
A non-standard paper size is specified.
200/250/350
or to specify the length.
7
7-11