MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting handlebar position
9.23
1
0 0 1
2
0 0 2
x
–
Remove the four screws
lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Fit and tighten the two screws
Guideline
400271-10
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Fit and evenly tighten the four screws
Guideline
Screw, handlebar clamp
. Remove the handlebar clamp. Remove the handlebar and
. Remove the handlebar support.
M10
M8
20 Nm
(14.8 lbf ft)
78
.
40 Nm
(29.5 lbf ft)
.
Loctite
®
243™