Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
Bleeding the fork legs
9.16
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
–
Loosen locking ring
–
Turn adjusting ring
Hook wrench (T106S)
–
Measure the overall spring length without a load.
–
Tension the spring by turning the adjusting ring
Guideline
Spring preload
700541-01
–
Tighten locking ring
–
Install the shock absorber.
–
Lean the motorcycle on the side stand.
x
.
until the spring is no longer under tension.
18 mm (0.71 in)
.
x
to the prescribed value.
72
Advertisement
Table of Contents
