Installing The Battery - KTM 690 SMC USA 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Installing the battery

x
9.56
–
Disconnect the negative (minus) cable of the battery.
–
Pull off the plug connector
–
Remove screws
–
Pull the retaining bracket
–
Take off the positive pole cover
–
Disconnect the positive (plus) cable of the battery.
–
Push the wiring harness to the side and pull the battery out of the battery rack.
Info
100277-10
Never operate the motorcycle with a discharged battery or without a battery. In
both cases, electrical components and safety devices can be damaged. The vehi-
cle is therefore no longer roadworthy.
–
Slide the battery into the battery rack.
Info
The battery terminals must be at the rear.
–
Attach the positive cable and mount positive terminal cover
–
Position retaining bracket
–
Mount and tighten screws
Guideline
100277-11
Remaining screws, chassis
–
Plug in connector
–
Attach the minus cable .
–
Mount the seat. (
upwards.

.

of the battery forward and remove it.

.

.

.

.

p. 116)
.

M6 10 Nm (7.4 lbf ft)
117