Starting Up; Shifting, Riding - KTM 690 SMC USA 2010 Owner's Manual

Motorcycle
Hide thumbs Also See for 690 SMC USA 2010:
Table of Contents

Advertisement

RIDING INSTRUCTIONS

Starting up

7.3
Pull the clutch lever, engage 1st gear, release the clutch lever slowly and simultaneously open the throttle carefully.

Shifting, riding

7.4
Warning
Danger of accidents Abrupt load alterations can cause the vehicle to get out of control.
Avoid abrupt load alterations and sudden braking actions, and adapt your speed to the road conditions.
Warning
Danger of accidents If you change down at high engine speed, the rear wheel can lock up.
Do not change into a low gear at high engine speed. The engine races and the rear wheel can lock up.
Info
Do not press the electric starter button until the function test of the combination
instrument is finished.
When starting, DO NOT open the throttle. If you open the throttle during the start-
ing procedure, fuel is not injected by the engine management system and the
engine cannot start.
Press the starter for a maximum of 5 seconds. Wait for at least 5 seconds before
trying again.
This motorcycle is equipped with a safety start system. You can only start the
engine if the gearbox is in neutral or if the clutch is pulled when a gear is
engaged. If the side stand is folded out and you shift into gear and release the
clutch, the engine stops.
Take the weight off the side stand and swing it back up with your foot as far as it will
go.
50

Advertisement

Table of Contents
loading

This manual is also suitable for:

690 smc

Table of Contents