Extron electronics IN1604 DTP User Manual page 13

Sleeve ( )
RCA Connector
Power connector — Connect the standard IEC power cord from a 100 to 240 VAC,
A
50-60 Hz power source into this connector. The front panel control and input selection
buttons light in sequence during power-up.
Tip (+)
Analog video connector — Connect a video source to the 15-pin HD connector. It
B
Ring (-)
accepts RGB, YUV, S-video, and composite video (see
page 9).
HDMI input connectors — Connect video sources to the HDMI connectors.
C
Sleeve ( )
Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the device
TIP:
3.5 mm Stereo Plug Connector
(see HDMI Connections
(balanced)
Analog audio input connector — Connect an audio source to the 3.5 mm
D
tip-ring-sleeve (TRS) connector for unbalanced analog audio.
Tip (L)
Ring (R)
Sleeve ( )
3.5 mm Stereo Plug Connector
(unbalanced)
Figure 3. TRS Wiring
Analog audio input connector — Connect an audio source to the 5-pole captive
E
screw connector. Wire the connector for line level, balanced or unbalanced, analog
stereo.
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Input
Figure 4. Audio Input Connector Wiring
Analog audio output connector — Connect audio output devices to this 5-pole
F
captive screw connector. Wire the connector for line level, balanced or unbalanced,
analog stereo.
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Output
Figure 5. Audio Output Connector Wiring
TP output connector and TP output switch (IN1604 DTP only) — Connect a DTP
G
receiver or HDBaseT-enabled device to the TP output RJ-45 connector to send all
signals over a single twisted pair cable (see
Communication on page 11 for wiring and cable recommendations).
Use the recessed switch to the right of the connector to set the signal type to the
type of receiver connected to the TP output connector. Position the switch Up to
send HDBaseT signals. Position the switch Down to send DTP signals.
ATTENTION: Position this switch BEFORE connecting the appropriate device to
the TP connector. Failure to comply can damage the endpoint.
ATTENTION : Positionnez ce interrupteur AVANT d'alimenter le point de connexion
connecté. Ne pas respecter cela pourrait endommager le point de connexion.
Analog Video Wiring
on page 10).
Tip
Sleeve
Tip
Sleeve
Unbalanced Audio Input
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
Twisted Pair Recommendations for DTP
IN1604 DTP and IN1604 HD Scalers • Installation
on
Do not tin the wires!
Do not tin the wires!
HDBT
DTP
7