Connecting A Mobile Device In Access Point Connect Mode - Fujitsu ScanSnap iX100 Basic Operation Manual

Connecting a Mobile Device in Access Point Connect Mode

By using the ScanSnap Wireless Setup Tool Wizard, you can configure and check the connection
between the ScanSnap and a mobile device.
For details, refer to "Setting a Wireless LAN Using the ScanSnap Wireless Setup Tool" (page
The following explains how to connect the ScanSnap and a mobile device when the wireless settings
have already been configured by using the ScanSnap Wireless Setup Tool Wizard.
1.
Start ScanSnap Connect Application on your mobile device.
a The mobile device will automatically be connected to an available ScanSnap on the same
network.
HINT
l If more than one available ScanSnap is detected when ScanSnap Connect Application is set
for a mobile device not to be connected to a ScanSnap automatically, tap the name of the
scanner that you want to connect the mobile device to under [Scanner] on the [Connect to]
screen. For details, refer to the ScanSnap Connect Application User's Guide for your mobile
device.
l When the ScanSnap and a mobile device are connected via wireless LAN, communication
with ScanSnap Manager is disconnected, and the pop-up balloon notifies you of the
communication status.
l With the ScanSnap and the mobile device already connected via wireless LAN, when you log
onto the computer which is connected to the ScanSnap, a pop-up balloon notifies you of the
status.
Connecting the ScanSnap via Wireless LAN
60
57).