Connecting The Scansnap To A Mobile Device In Access Point Connect Mode (Ix1500) - Fujitsu ScanSnap iX1600 Basic Operation Manual

Connecting the ScanSnap to a Mobile Device in Access Point
Connect Mode (iX1500)
Configure the wireless settings for the ScanSnap in the ScanSnap Wireless Setup Tool Wizard or on
the touch panel to complete the preparation for connecting the ScanSnap to a mobile device.
For details, refer to the following:
l "Connecting the ScanSnap to a Wireless Access Point by Using the ScanSnap Wireless Setup
Tool (iX1500)" (page 115)
l "Connecting the ScanSnap to a Wireless Access Point from the Touch Panel (iX1500)" (page
116)
The following explains how to connect the ScanSnap and a mobile device when the wireless settings
for the ScanSnap have already been configured.
1.
Start ScanSnap Connect Application on your mobile device.
a The mobile device will automatically be connected to an available ScanSnap on the same
network.
HINT
l If more than one available ScanSnap is detected, or if ScanSnap Connect Application is set
not to connect a mobile device to a ScanSnap automatically, then tap the ScanSnap that you
want by name, in order to connect to the mobile device, under [ScanSnap] on the [Connect
to] screen. For details, refer to the Basic Operation Guide (Mobile Connection) for your
mobile device.
l A notification appears in the following cases:
- When the ScanSnap and the mobile device are connected via wireless LAN, and the
communication with ScanSnap Manager is disconnected
- When you log onto the computer which is connected to the ScanSnap with the ScanSnap
and the mobile device already connected via wireless LAN
Connecting the ScanSnap to a computer or mobile device via Wireless LAN (iX1500)
122