Fujitsu ScanSnap iX100 Basic Operation Manual page 114

Press the [Scan/Stop] button to rotate the roller. Gently wipe the dirt and dust off while
taking care not to damage the surface of the roller. Make sure that they are cleaned
properly because residue on the roller will affect the feeding performance.
l Eject roller (× 1)
Press the [Scan/Stop] button to rotate the roller. Gently wipe the dirt and dust off while
taking care not to damage the surface of the roller. Make sure that they are cleaned
properly because residue on the roller will affect the feeding performance.
If eject roller is difficult to clean, try cleaning it from the back while you keep the top
cover slightly open.
HINT
Pressing the [Scan/Stop] button seven times will rotate the feed roller and the eject roller one
revolution.
3.
Close the top cover and the output guide.
Top Cover
a It clicks when it returns to its original position.
ATTENTION
Make sure that the top cover is completely closed.
Otherwise, paper jams or other feeding errors, or image faults may occur.
Eject Roller (x 1)
Output Guide
Feed Guide
114
Cleaning the Inside of the ScanSnap