Connecting A Computer In Direct Connect Mode - Fujitsu ScanSnap iX100 Basic Operation Manual

Connecting a Computer in Direct Connect Mode

By using the ScanSnap Wireless Setup Tool Wizard, you can configure and check the connection
between the ScanSnap and a computer.
For details, refer to "Setting a Wireless LAN Using the ScanSnap Wireless Setup Tool" (page
The following explains how to connect the ScanSnap and a computer when the computer to be
connected has already been registered by using the ScanSnap Wireless Setup Tool Wizard.
1.
Click in the notification area located at the far right of the taskbar, and
connect the following network displayed in the wireless network list.
The network name (SSID) and the security key are printed on the label attached to the bottom
of the scanner.
HINT
The network name (SSID) and the security key can be checked or changed with the ScanSnap
Wireless Setup Tool.
2.
Disconnect the USB cable connecting the ScanSnap to the computer.
ATTENTION
If the ScanSnap Manager icon is
a The ScanSnap is automatically connected to a computer via wireless LAN and the
ScanSnap Manager icon changes to
If the icon does not change, go to step 3.
HINT
l If the [Connect automatically to previous ScanSnap by Wi-Fi] checkbox is selected and the
previously connected ScanSnap is available for the connection, the computer is connected to
the ScanSnap automatically.
l The computer can be connected to only one ScanSnap.
l Only one computer can be connected to the ScanSnap via wireless LAN.
l When you use automatic connection for the ScanSnap that had been connected with a
wireless LAN before, if the password for the ScanSnap to be connected is changed, a pop-up
balloon notifies you of the status.
3.
Right-click the ScanSnap Manager icon
the far right of the taskbar and select [Connect by Wi-Fi] from the
Click Menu" (page
, exit ScanSnap Connect Application on the mobile device.
.
45).
61
Connecting the ScanSnap via Wireless LAN
in the notification area located at
57).
"Right-