Fujitsu ScanSnap iX100 Basic Operation Manual page 113

Wipe off the cleaner completely to leave no residue on the cleaned parts.
Glass (x 2)
l Glass (× 2, one on the top cover and one on the opposite side)
Gently wipe the dirt and dust off the surface of the glass sections.
l Idler roller (× 12, located on the top cover)
Gently wipe the dirt and dust off the rollers as you rotate them manually. Be careful not
to damage the surface of the rollers. Make sure that they are cleaned properly because
residue on the rollers will affect the feeding performance.
2.
Clean the feed roller and eject roller.
1. Press the [Scan/Stop] button for three seconds with the top cover open.
2. Clean the following locations with a cloth moistened with Cleaner F1.
ATTENTION
l Do not use water or mild detergent to clean the inside of the ScanSnap.
l It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the
cloth with moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
l Feed roller (× 1)
Idler Roller (x 12)
Eject Roller (x 1)
Feed Roller (x 1)
113
Cleaning the Inside of the ScanSnap