SOYO SY-P4I875P DRAGON 2 User Manual page 140

connected, like CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer I get "floppy boot failure" and
the LED on the floppy stays on
1. Make sure the red wire of floppy ribbon cable goes to Pin1
on the floppy drive side (don't trust the "key lock" or "notch")
and use the end-connector of the cable (don't use middle
one).
2. Some floppy drivers have their own jumper to make the
same twist as the twist on the cable. Make sure this jumper is
set not to "twist" the cable while the floppy drive is
connected to the twisted end of the cable.
RAID issue
Windows does not detect the on-board RAID.
1. Enable the on-board RAID function in the BIOS.
2. install the RAID driver, see chapter 6 for more info.
Can I use my CD-ROM or other IDE device (except HDD) on IDE 3 & 4,
SATA 1-4?
No, the HPT 372N and all SATA ports only support Hard disks.
Can I use IDE 3 & 4 and / or SATA 1-4 as a normal IDE channel?
Yes, no need to change any settings in the BIOS. Just make sure to install
the driver, check Chapter 6 for more info.
I cannot get the HDD to boot from IDE 3 or IDE 4, why?
Make sure that the 1
I cannot get the HDD to boot from SATA1 or SATA2, why?
SATA1 and SATA2 are not bootable.
st
boot device in the BIOS is set to SCSI.
140