SOYO SY-P4I875P DRAGON 2 User Manual page 122

press Enter
5. Select 2. Select Disk Drives
6. Select the harddisks to be used for creating the disk array and press
Enter to confirm.
7. Select 3. Start Creation Process
8. Pay attention to the warning message, and press
creation.
Note:
1. If you have selected
popup sub-interface after the operation of
should directly go to
Creation Process
2. If user is creating RAID 0+1, then user must select four single
disks. All data on these disks will be destroyed after creation of
RAID 0+1.
3. Different warning messages appear according to different RAID
levels.
II. Delete RAID
The following steps shall be taken to delete RAID.
1.
In the menu zone, select
this operation and go to next.
2.
In the validated channel status, use the arrow key to select the disk
array to be deleted and press
3.
Press Y
array?
III. Rebuild Mirror Array
The following steps shall be taken to rebuild the mirror array.
1.
In the menu, select
confirm.
2.
In the menu, select
to confirm.
.
Striping (RAID 0) for Performance
3. Strip Size 64K
. The default strip size is
when warned Are you sure you want to remove the disk
3. Rebuild Mirror Array
1. Select Source Disk: None
in the menu and press
.
and then select
2. Delete RAID , press
Enter to confirm.
122
Enter .
Y to finish
1. Array Mode
4. Start
64K .
Enter to confirm
, press Enter
and press
in the
, you
to
Enter