(DOWN)
utes.
4. Press (DISPLAY)
water temperature display. Note: If no button is pressed within 30
seconds, all changes are recorded and the screen automatically
returns to the standard water temperature display.
When a programmed filter/heating cycle activates, the LCD screen
displays the following message:
At any time, you may check the programming of any aspect of any
filter/heating cycle by first pressing (CYCLE)
moving through the menu by pressing either (CYCLE)
(SELECT)
or (DOWN)
(UP)
12.3 Adjusting Time of Day
The Sentry control system remembers the time of day even in the event
of a prolonged power outage. However, it may occasionally be neces-
sary to reset the time of day. For example: if you are not in the Pacific
Time Zone you will want to reset the time for your own time zone. (The
system will automatically adjust to and from daylight savings time.) To
accomplish this, press (DISPLAY)
PLAY)
button within five seconds each. A number representing the
hour will be displayed, followed by AM or PM. The hour will advance or
decrease each time (UP)
seconds. Then, press (DISPLAY)
utes. Adjust the minutes as necessary by pressing (UP)
button. After 5 seconds, the display will return to normal and save
your settings.
12.4 Main Control Panel Lock
To help prevent unauthorized use of your hot tub, the Sentry con-
trols incorporate a unique panel locking system which disables the
controls on the panel.
•
To Lock The Main Control Panel: Press (DISPLAY)
(MODE)
each. A padlock symbol will appear on the LCD screen.
button to adjust the duration in increments of 15 min-
button to save changes and recall the main
1*
button. The programming is changed only by pressing
buttons during this process.
or (DOWN)
and (UP)
, (MODE)
button is pressed within five
button again to display the min-
buttons within five seconds
*Note: Number will vary
according to which
filter cycle is being pro-
grammed.
button then
or
and (DIS-
or (DOWN)
,
Page 51
LOCKED
LOCKED